Terminator T1 Pepper
The T1-Pepper provides customizable (active) termination for PROFIBUS segments that do not comply with the standard RS 485 impedance. With rotary switches the impedance of the termination can be set.Request offer
PROFIBUS networks exist that have not been wired with proper cable or where it is mandatory to use existing twisted pair cable. The T1-Pepper is an excellent solution to adapt the termination to the impedance of the cable. It can also be used to increase the idle line voltage on segments where interference causes communication disturbances and the large connectors allow specialty cable or more cable stress.
2 Rotary switches manipulate the values of the termination network. One for the middle resistor and one for the 2 pull-up resistors. The combination of both set the impedance and the level of the idle voltage. The T1-Pepper is a partner product for the COMbricks SALT repeater that requires termination at the other side of the cable. The rotary switches have to be set identical at both sides.
The T1-Pepper can be used by all fieldbuses that require active termination. It has a redundant power supply and diagnostic LEDs to indicate the status of each power source. It can be installed on a standard DIN-rail.
Check the most frequently asked questions about ComBricks.
Worldwide PROFIBUS and PROFINET support; on-site and online.
Find out what PROCENTEC can certify in your network.
Find and download all the GSD files you need.
Request firmware, software and download GSD-files.
'Distinguish yourself from the others and show that you are the expert.....Become a Certified PROFIBUS Engineer.'
The PROFIBUS Troubleshooting and Maintenance training course is fully concentrated on those who install and maintain PROFIBUS installations.
This training course is especially suited for product vendors and engineering companies who want to develop a PROFIBUS product.